Allied Manta Guia de Instalação descarregar pdf (Página 36)

AVT Manta cameras: installing hardware and software

Manta Hardware Installation Guide V4.1.0

3. Optional: Configure IP settings manually: Again double-click the net-

work connection corresponding to the network card that was just

installed. In the list of items select Internet Protocol (TCP/IP) and

click Properties. You can see the automatically obtained IP address.

Take over this IP address by choosing Use the following IP address and

click OK.

4. Optional: Open the IP settings from IPConfig program (which is

installed automatically when installing the GigE Sample Viewer

program):

5. Start  All Programs  Allied Vision Technologies  GigEIPConfig



C:\Program Files\Allied Vision Technologies\GigEViewer\ipconfig.exe)

6. Choose desired GigE camera and click Change. Take over the IP address/

Subnet mask from your camera list. Choose Use the following

Persistent IP address, enter this IP address/Subnet mask and click OK.

7. Check exposure time and gain. You should now see an image.

Figure 15: Using Persistent IP address for camera

Note



Background: Automatic acquiring of an IP address may take

some time (up to one minute). To shorten this time, you can

manually enter IP address for your Gigabit Ethernet network

card and also for your GigE camera as described above.

If you want to enter IP addresses manually without getting

IP address automatically before, you need knowledge about

your network (DHCP server, APIPA) and knowledge of private

IP addresses. For more information read

Chapter Trouble-

shooting on page 54ff.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 60 61

Sem comentários

Allied Manta Guia de Instalação Página 36