Allied Manta Guia de Instalação descarregar pdf (Página 43)

Camera interfaces

Manta Hardware Installation Guide V4.1.0

Camera interfaces

Each AVT Manta camera has the following interfaces:

• The 12-pin camera I/O connector provides different control inputs and

output lines and external power (via external power supply).

• One GigE connector with screw lock mechanism provides access to the

GigE network and thus makes it possible to control the camera and out

put frames. For cameras that are PoE capable, the GigE connector can be

used to provide power to the camera.

Note



For information on status LEDs see Chapter Status LEDs

(MANTA) on page 45.

Note



• If you supply power via PoE, the power must comply

with IEEE 802.3at.

• If both interfaces are used for power (I/O and GigE

connector via PoE), the camera will only use the power

from the I/O connector.

How can I distinguish between PoE capable cameras and

cameras that are not PoE capable?

• PoE capable cameras have the letters PoE written on

the camera’s label on the back side and the bottom side

of the camera.

• PoE capable cameras have the GigE jack upside down.

Exception

Manta G-145-30fps and Manta G-201-30fps (non PoE):

• ... have same I/O pin assignment (input circuits and

voltage range), power LED and upside down PoE plug as

PoE models.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 60 61

Sem comentários

Allied Manta Guia de Instalação Página 43